HP ProCurve 1600M Suplemen Manual - Halaman 21

Jelajahi secara online atau unduh pdf Suplemen Manual untuk Beralih HP ProCurve 1600M. HP ProCurve 1600M 28 halaman. Redundant power supply
Juga untuk HP ProCurve 1600M: Lembar Spesifikasi (12 halaman), Baca Saya Terlebih Dahulu (8 halaman), Panduan Peninjau (27 halaman), Panduan Tambahan (2 halaman), Panduan Tambahan (2 halaman), Panduan Instalasi (28 halaman), Panduan Instalasi (36 halaman), Panduan Instalasi (28 halaman), Panduan Pengaturan Cepat (2 halaman), Panduan Pengaturan Cepat (4 halaman), Panduan Pengguna (8 halaman), Baca Saya Terlebih Dahulu (16 halaman), Instalasi dan Penghapusan (2 halaman), Panduan Instalasi (12 halaman), Panduan Perencanaan dan Pelaksanaan (40 halaman), Petunjuk Pembongkaran Akhir Masa Pakai Produk (2 halaman), Panduan Instalasi (46 halaman), Panduan Diagnostik (2 halaman), Petunjuk Pembongkaran (2 halaman)

Displaying VRRP Statistics

Use the following methods to display VRRP statistics.

NOTE: It is normal for the VRRP statistics to be zero. Zeros indicate that no errors have occurred and that the

owner is still the Master.

USING THE CLI

To display VRRP statistics for a router, enter the following command:

Router1(config)# show ip vrrp stat

Here is an example of the information displayed by this command:

Interface ethernet e 1/6

rxed vrrp header error count = 0

rxed vrrp auth error count = 0

rxed vrrp auth passwd mismatch error count = 0

rxed vrrp vrid not found error count = 0

VRID 1

rxed arp packet drop count = 0

rxed ip packet drop count = 0

rxed vrrp port mismatch count = 0

rxed vrrp ip address mismatch count = 0

rxed vrrp hello interval mismatch count = 0

rxed vrrp priority zero from master count = 0

rxed vrrp higher priority count = 0

transitioned to master state count = 1

transitioned to backup state count = 0

USING THE WEBMANAGEMENT INTERFACE

To display VRRP statistics, select Show from the System configuration sheet, then select either Virtual Router or

Interface:

•

If you select Virtual Router, the panel shown in Figure 7 is displayed.

•

If you select Interface, the panel shown in Figure 8 is displayed.

Figure 7

VRRP router statistics

Configuring VRRP