Olympus BH2-6RE Manual - Halaman 9

Jelajahi secara online atau unduh pdf Manual untuk Mikroskop Olympus BH2-6RE. Olympus BH2-6RE 18 halaman.

Figure 13 – Remove the pivot-adjustment screw

Remove the Center-Pivot Bearing Ball

Use a tweezers to remove the ¼" bearing ball from the

center bore in the stationary base (see

Figure 14 – Remove the center-pivot bearing ball

The next step is to remove the mechanical detent stop.

Use a suitable JIS screwdriver to remove the two M2X4

pan-head screws securing this stop to the stationary

base of the turret assembly (see

screws are staked in place with adhesive and can be

surprisingly stubborn to remove, so be sure to use the

proper JIS screwdriver to prevent damaging the screw

heads. It might also be helpful to heat the screws with

a heat gun before loosening them, but do not melt the

black knurled-rubber grip ring in the process.

Complete Teardown, Cleaning, and Reassembly of the Olympus BH2-6RE Modular Revolving Nosepiece

Figure

14).

Figure

15). These

Figure 15 – Remove the screws securing the detent stop

Remove the loose mechanical detent stop from the

stationary base (see

Figure

Figure 16 – Remove the mechanical detent stop

Carefully remove the black knurled-rubber grip ring

from the outer perimeter of the revolving turret (see

Figure

17), being careful not to stretch or damage it in

the process. This ring is held onto the turret with a few

spots of adhesive, so proceed carefully here.

Figure 17 – Remove the knurled-rubber grip ring

16).

Page 9 of 18

Revision 3