Olympus BH2-CH Substage Perakitan - Halaman 21

Jelajahi secara online atau unduh pdf Perakitan untuk Mikroskop Olympus BH2-CH Substage. Olympus BH2-CH Substage 26 halaman.

Apply fresh grease to both sides of the small nylon

washer. Place the nylon washer into the recess in the

inner ledge of the main housing (see

grease will hold the nylon washer in place during the

subsequent reassembly steps.

Figure 82 – Place washer in recess in the main housing

Apply fresh grease to the bore in the left-hand side of

the main housing (see

Figure

Figure 83 – Grease the left-hand bore in main housing

Place the metal flat washer over the pinion shaft.

Lightly grease the pinion shaft (see

Figure 84 – Place metal washer over greased pinion shaft

Insert the greased pinion shaft into the bore on the

right-hand side of the main housing (see

Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly

Figure

82). The

83).

Figure

84).

Figure

85).

Figure 85 – Insert pinion shaft into the right-hand bore

Use a suitable blunt tool (i.e., one with a tip wide

enough such that it does not damage the dimple for the

bearing ball in the end of the pinion gear) to press the

pinion shaft fully into the right-hand bore in the main

housing, until the pinion gear comes to rest on the

nylon washer on the internal ledge of the main housing

(see

Figure

86).

Figure 86 – Seat pinion gear onto main housing ledge

Apply a bit of fresh grease to the depression in the end

of the tension screw (see

Figure 87 – Apply grease to the end of the tension screw

Figure

87).

Revision 1

Page 21 of 26