Olympus BH2-CH Substage Perakitan - Halaman 23

Jelajahi secara online atau unduh pdf Perakitan untuk Mikroskop Olympus BH2-CH Substage. Olympus BH2-CH Substage 26 halaman.

Use a 1.5mm Allen wrench or driver to tighten the two

M3x4 set screws to secure the condenser-height knob

to the condenser-height shaft (see

Figure 94 – Tighten set screws to secure the height knob

Adjust the Tension of the Condenser-Height Shaft

Use a suitable slotted screwdriver to tighten the tension

screw until the condenser-height knob has the desired

feel, with no thrust play in the condenser-height shaft

(see

Figure

95).

Figure 95 – Adjust tension screw for no thrust play

Use a suitable tool (e.g., sharp needle-nose pliers) to

snug the lock nut for the tension screw, to lock the

tension screw in position (see

Figure 96 – Tighten lock nut to secure tension screw

Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly

Figure

94).

Figure

96).

Place the right-hand dovetail block into position on the

main housing (see

Figure

M2x8 alignment pins in the dovetail block seat into the

alignment holes in the main housing.

Figure 97 – Place right-hand dovetail block onto housing

Use a 2.5mm Allen wrench or driver to reinstall three

M3x6 hex socket-head cap screws to secure the right-

hand dovetail block onto the main housing (see

98).

Figure 98 – Reinstall screws to secure right dovetail block

Place the left-hand dovetail block into position on the

main housing (see

Figure

M2x8 alignment pins in the dovetail block seat into the

alignment holes in the main housing.

Figure 99 – Place left-hand dovetail block onto housing

97). Make sure that the two

Figure

99). Make sure that the two

Revision 1

Page 23 of 26