Olympus BH2-CH Substage Assembly - Page 23
Parcourez en ligne ou téléchargez le pdf Assembly pour {nom_de_la_catégorie} Olympus BH2-CH Substage. Olympus BH2-CH Substage 26 pages.
![Olympus BH2-CH Substage Assembly](/uploads/products/server2/4281661/4281661.png)
Use a 1.5mm Allen wrench or driver to tighten the two
M3x4 set screws to secure the condenser-height knob
to the condenser-height shaft (see
Figure 94 – Tighten set screws to secure the height knob
Adjust the Tension of the Condenser-Height Shaft
Use a suitable slotted screwdriver to tighten the tension
screw until the condenser-height knob has the desired
feel, with no thrust play in the condenser-height shaft
(see
Figure
95).
Figure 95 – Adjust tension screw for no thrust play
Use a suitable tool (e.g., sharp needle-nose pliers) to
snug the lock nut for the tension screw, to lock the
tension screw in position (see
Figure 96 – Tighten lock nut to secure tension screw
Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly
Figure
94).
Figure
96).
Reinstall the Dovetail Blocks
Place the right-hand dovetail block into position on the
main housing (see
Figure
M2x8 alignment pins in the dovetail block seat into the
alignment holes in the main housing.
Figure 97 – Place right-hand dovetail block onto housing
Use a 2.5mm Allen wrench or driver to reinstall three
M3x6 hex socket-head cap screws to secure the right-
hand dovetail block onto the main housing (see
98).
Figure 98 – Reinstall screws to secure right dovetail block
Place the left-hand dovetail block into position on the
main housing (see
Figure
M2x8 alignment pins in the dovetail block seat into the
alignment holes in the main housing.
Figure 99 – Place left-hand dovetail block onto housing
97). Make sure that the two
Figure
99). Make sure that the two
Revision 1
Page 23 of 26