Olympus BX51M Petunjuk Manual - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Mikroskop Olympus BX51M. Olympus BX51M 36 halaman. System metallurgical microscope

IMPORTANT

This microscope employs a UIS2 (UIS) (Universal Infinity System) optical design, and should be used only

with UIS2 (UIS) eyepieces, objectives and condensers for the BX2 series. (Some of the modules de-

signed for the BX series are also usable. For details, please consult Olympus or the latest catalogue.)

SAFETY PRECAUTIONS

Fig. 1

Fig. 2

1. Install the microscope on a sturdy, level table or bench so as not to

block the air vents on the underside of the base.

2. When moving the microscope, carefully carry it with the grasping part on

the arm as shown in Fig. 1 (Weight: approx. 15 kg).

# Damage to the microscope will occur if you grasp it by other parts

including the stage, lamp socket or tube.

# Before transporting the microscope, be sure to remove the speci-

men and eyepieces so that they will not drop. Also remove other

modules attached to the microscope because they increase the

system weight.

3. The surface of the lamp housing @ becomes very hot during operation.

Before installing the lamp housing, be sure to reserve enough space

around, particularly above, the lamp housing.

4. To avoid potential shock hazards and burns when replacing the light

bulb, set the main switch ² to "

cord from the wall outlet in advance. Whenever you replace the bulb

during use or right after use, allow the lamp housing @ and bulb to cool

before touching (Fig. 2).

Designated

halogen bulbs

# The microscope also incorporates a fuse (this should be replaced

by the manufacturer or authorized agent).

5. Always use the power cord provided by Olympus. If no power cord is

provided, please select the proper power cord by referring to the chapter

"PROPER SELECTION OF THE POWER SUPPLY CORD" at the end of

this instruction manual. If the proper power cord is not used, product

safety and performance cannot be guaranteed.

6. Always ensure that the grounding terminal of the microscope and that

of the wall outlet are properly connected. If the equipment is not grounded,

Olympus can no longer warrant the electrical safety and performance of

the equipment.

7. Never insert metal objects, etc. into the air vents of the microscope frame

as this could result in electrical shock and personal injury.

8. The microscope system will be unstable when its height is increased by

attached accessories. Take proper measures so that the system will not

topple down.

" (OFF) then disconnect the power

12V100WHAL-L (PHILIPS 7724)

12V50WHAL-L (LIFE JC)