Olympus BX61 Petunjuk Manual - Halaman 18

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Mikroskop Olympus BX61. Olympus BX61 40 halaman. Motorized system microscopes

Halaman Cetak

Fig. 20

Fig. 21

Adjusting the X/Y-Axis Knob Tension

1. Hold the X-axis knob @ and slide up the Y-axis knob ² up to expose the

adjustment knobs.

2. Turning the X-axis adjustment knob ³ or Y-axis adjustment knob | clock-

wise (in the direction of the arrow) increases the rotation tension and

counterclockwise decreases it.

# If the tension is adjusted too tight, a creaking sound may be heard

during stage travel, and the stage stopping accuracy may be imper-

iled.

After long hours of use, the stage guide may be devi-

CAUTION

ated and the stage travel range may be decreased.

However, this is not malfunction and can be corrected

easily as described below.

[Treatment] X-axis direction: Hold the specimen holder and move the

Y-axis direction: Hold the upper stage and move it to the front

Rubber Stage Knob Caps (Optional)

}When the X/Y-axis knobs are fitted with the rubber caps, the knobs can

be adjusted without slipping and fine adjustment is possible by holding

the knobs with a very light force. The knob rubber caps also reduce

fatigue after long hours of operation.

The U-SHGT thick type (thickness 5 mm) and U-SHG thin type (thickness

2 mm) knob rubber caps are available.

To attach the knob rubber caps:

First fit the larger rubber knob cap to the Y-axis (upper) knob from below

it, then fit the smaller rubber knob cap to the X-axis (lower) knob from

below it.

Rotating the Stage

1. Slightly loosen the stage clamping knob @.

2. The stage can be rotated both clockwise and counterclockwise while

holding the stage clamping knob.

# A click may be heard and felt during rotation. However, this is due to

the construction of the substage and does not indicate a malfunc-

tion.

}The angle of rotation varies depending on the positions of the feed knobs.

Right-hand knobs

Left-hand knobs

stage guide to the left and right so that it hits

the stoppers.

and rear so that it hits the stoppers.

Angle of Rotation

Clockwise

Counterclockwise

230°

20°

(Fig. 20)

(Fig. 21)

20°

230°