Axminster AW19FM Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Axminster AW19FM. Axminster AW19FM 12 halaman. Morticers
Juga untuk Axminster AW19FM: Panduan Pengguna (20 halaman)

Halaman Cetak

Installing the Chisel and Bit...

A X M I N S T E R

W H I T E

1. Select the size of mounting bush to suit the chisel being used and fit into the morticing

head.

2. Insert the chisel into the bush and tighten the screw just enough to hold the chisel in

place. Rotate the chisel so that the slot in the side of the chisel is positioned either to the

left or right, not the front or back; this will allow the chips to escape freely when cutting.

3. Push the chisel fully into the bush and then retract it by about 1.5 mm, using a spacer

such as a coin as shown in Fig E to establish the correct position. Tighten up the locking

screw.

4. Insert the auger into the chisel and push it fully up so that it contacts the recess in the

end of the chisel and then fully secure the shank of the auger in the chuck.

Be careful when handling morticing chisels as the ends are very sharp.

5. Now slacken off the chisel clamping screw, remove the spacer, push the chisel fully home

and re-tighten the screw. This procedure will ensure that there is a small clearance between

the end of the auger and the chisel, essential in order to avoid waste jamming and

overheating the chisel.

6. The final operation is to check that the chisel is perfectly square to the table; this is best

done by bringing the table forward until the vertical face just touches the back face of the

chisel and using this as a datum for aligning the chisel. Ensure that the chisel is securely

clamped in position before starting work.

Fig E

Illustrated Parts List for AW19FM...

A X M I N S T E R

W H I T E