Axminster Craft AC150WSG Manual Petunjuk Asli - Halaman 8
Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Penggiling Axminster Craft AC150WSG. Axminster Craft AC150WSG 13 halaman. Wide stone grinder
Halaman Cetak
Changing a Grinding Wheel
ENSURE THAT THE GRINDER IS
DISCONNECTED FROM THE MAINS
SUPPLY.
Undo the nuts and bolts that secure the outer shell of the
wheel guard to the inner shell. Remove the outer shell and
place it and the nuts, bolts and washers carefully aside.
(See fig 6)
Fig 6.
Loosen the nut holding the grinding wheel to the shaft. Carefully remove the nut, the plate flange and the soft washer
that is clamping the grindstone in place. (See figs 8 & 9) Then, very carefully remove the grindstone from the shaft, take
care that no damage or distortion is done to the bush (if one is fitted). (See fig 10) Now is a good time to clean out the
interior of the wheel guard, removing any loose or compacted material that may have accumulated. Carefully inspect the
new grinding wheel before it is fitted, check that there are no cracks, and there is no damage to either the front face or
the edges. If required, fit the bush to the grindstone. Carefully mount the grindstone onto the shaft, reposition the soft
washer and the wheel flange, replace the holding nut and tighten carefully. Do Not Overtighten. Refit the outside shell of
the wheel guard and secure with its nuts and bolts. Refit the tool rest, positioning as in "Setting up the grinder". Fasten
securely.
Fig 8.
Nut
BE VERY CAREFUL THAT THE STONE
COVER DOES NOT 'SPRING' OUT OF
ITS LOCATION LIP ON THE INNER
COVER, IT CAN SPRING OUT WITH
SOME FORCE. (SEE FIG 7)
Fig 7.
Fig 9.
Plate flange
8