- ページ 8

グラインダー Axminster Craft AC150WSGのPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。Axminster Craft AC150WSG 13 ページ。 Wide stone grinder

Changing a Grinding Wheel

ENSURE THAT THE GRINDER IS

DISCONNECTED FROM THE MAINS

SUPPLY.

Undo the nuts and bolts that secure the outer shell of the

wheel guard to the inner shell. Remove the outer shell and

place it and the nuts, bolts and washers carefully aside.

(See fig 6)

Fig 6.

Loosen the nut holding the grinding wheel to the shaft. Carefully remove the nut, the plate flange and the soft washer

that is clamping the grindstone in place. (See figs 8 & 9) Then, very carefully remove the grindstone from the shaft, take

care that no damage or distortion is done to the bush (if one is fitted). (See fig 10) Now is a good time to clean out the

interior of the wheel guard, removing any loose or compacted material that may have accumulated. Carefully inspect the

new grinding wheel before it is fitted, check that there are no cracks, and there is no damage to either the front face or

the edges. If required, fit the bush to the grindstone. Carefully mount the grindstone onto the shaft, reposition the soft

washer and the wheel flange, replace the holding nut and tighten carefully. Do Not Overtighten. Refit the outside shell of

the wheel guard and secure with its nuts and bolts. Refit the tool rest, positioning as in "Setting up the grinder". Fasten

securely.

Fig 8.

Nut

BE VERY CAREFUL THAT THE STONE

COVER DOES NOT 'SPRING' OUT OF

ITS LOCATION LIP ON THE INNER

COVER, IT CAN SPRING OUT WITH

SOME FORCE. (SEE FIG 7)

Fig 7.

Fig 9.

Plate flange