AccuraSEE MINI Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kipas angin AccuraSEE MINI. AccuraSEE MINI 5 halaman. Portable heat recovery ventilator

Halaman Cetak

Installation

Please, adhere to the following instructions when installing the product:

NOTE 

The product shall not be



The product shall not be installed near hazardous or toxic materials.

installed at a location

where there is probable



The product shall only be installed in either vertical or horizontal

contact with liquids.

orientations and shall not be positioned at an oblique angle.

NOTE 



The product shall be

The product shall be installed in horizontal orientation as shown in

carefully positioned

Figure 2(a).

such that it may not trip

and cause property



The product shall be installed in vertical orientation as depicted in

damage or bodily injury.

Figure 2(b).

NOTE 



The product shall not be

The product can be sited on a table / floor or mounted on a wall.

installed at a location

where there is excessive



The product shall be installed in a space where the temperature and

heat or exposure to

relative humidity of air are within the range of 22ºC – 26ºC

direct sunlight.

(71.6ºF – 78.8ºF) and 35% – 50%, respectively.

NOTE 



The pre-installed supply and exhaust ducts shall be insulated.

Accessories such as

screens, boards, duct

insulation, AC-to-DC



The vents and ducts shall NOT be connected to external appliances

power adapters, self-

such as dryers, fans, furnaces, etc.

tapping screws, and

wall-mounting brackets

are third-party goods



The product shall not be powered until the ducts are installed.

which may not be

provided by the



Window/Door: A pair of boards with each having one hole or a single

manufacturer.

board with two holes shall be fastened to a section of a window/door, and

NOTE 

the ducts shall be inserted into the holes.

The product may be

mounted on a wall by



Wall: The ducts shall be inserted into two holes that are drilled through

using four wall-

the wall.

mounting brackets and

four M5 × 10mm self-



tapping screws.

To power the product, connect the plug of the power adapter to the wall

power. Next, connect the free end of the power adapter to the power

NOTE 

connector port and the product will operate in the Normal mode. The

The board(s)/wall holes

Boost mode can be activated by pressing the power switch until it latches.

shall be ≥3 in (~7.6 cm).



To shut down the product, ensure that the Normal mode is active. Next,

NOTE 

disconnect the power adapter cord from the power connector port, and

The Boost mode can be

disconnect the plug of the power adapter from the wall power.

transitioned to Normal

by simply unlatching the

power switch.

Figure 2. Schematic depiction of the installation of the product in (a) horizontal (side view) and

(b) vertical (front view) orientations.

Although the supply duct is not visible in Figure 2(a), it may be connected to the board(s) to interface with the outdoors.

Note. Figure 2 is not drawn to scale.

NOTE 

RECOMMENDATIONS

Please comply with all



Screens, which are not provided by the manufacturer, may be attached to the holes of the

applicable codes and

board(s), ducts, or wall to prevent encroaching organisms from damaging the product or

regulations when

constituting hazard to the space where the product is installed.

installing the product.



When installing the product, a minimum separation distance of 1 ft is recommended

between the supply and exhaust ducts.



The ducts should be installed without any bends that may impede the flow of air.

(a) Horizontal orientation.

(b) Vertical orientation.