Accurate Technology Digi-Stop Panduan Pengguna - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur Accurate Technology Digi-Stop. Accurate Technology Digi-Stop 16 halaman. Complete digital stop and fence system for chop saws, radial arm saws, and miter saws
Readout Lock Mode
To activate the Lock function Press and hold the
momentarily press the
corner of the readout. When LOCK
become inactive to prevent accidental changes of the (calibrated) current
displayed position. To de-activate the Lock function, press and hold the
key and then momentarily press the
NOTE: The Lock function can also be enabled/disabled through programming.
This allows a more permanent Lock function since programming can be
disabled with a hardware jumper inside the readout thus preventing any front
panel programming changes.
See Section 3: Readout Programming,
Readout Resolution
The Digital readout can be configured to display measurements in any of three
different resolutions.
1. Low– the resolution is
2. Normal– the resolution is:
3. High– the resolution is:
The display of fractions remains the same for all settings: 1/16, 1/32 & 1/64
See Section 3: Readout Programming,
Making Incremental Measurements
The readout has two measurement modes, or indexes. One is referred to as
ABS or Absolute, and the other as INC, or Incremental. The absolute
measurement mode allows the operator to read the current position of the stop
referenced from a fixed or known position such as the saw blade.
The incremental mode allows the operator to make relative distance
measurements from one arbitrary point to another. The absolute position of
the Digi-Stop is not lost when using the incremental mode.
Absolute
The readout automatically enters ABS mode when power is first
applied. This is indicated by the ABS
display. While in the ABS mode, all stop positions are related to the current
ABS, or absolute system reference point, ie the blade..
Incremental
To enter the INC mode, press and hold the
approximately 3 seconds. The INC
of the display. When the INC mode is entered the readout will display zero (0)
or the last offset if one was entered, and may be changed by using the
Accurate Technology DigiStop
key. The word LOCK
UNITS
LOCK is displayed, the +,
LOCK
LOCK
UNITS
ABS symbol in the upper left corner of the
ABS
ABS
INC symbol will appear in the upper left corner
INC
INC
/
ON
OFF
LOCK
LOCK will appear in the upper left
LOCK
key.
Programming Parameter Pr3.
.1in or .1mm.
.01in or .01mm.
.001in or .01mm
Programming Parameter Pr4.
key and then
and
–
keys
DATUM
key for
UNITS
Page 11 of 16
/
ON
OFF
+
or
-