Accurate Technology Digi-Stop Руководство пользователя - Страница 11

Просмотреть онлайн или скачать pdf Руководство пользователя для Измерительные приборы Accurate Technology Digi-Stop. Accurate Technology Digi-Stop 16 страниц. Complete digital stop and fence system for chop saws, radial arm saws, and miter saws

Печатать страницу

Readout Lock Mode

To activate the Lock function Press and hold the

momentarily press the

corner of the readout. When LOCK

become inactive to prevent accidental changes of the (calibrated) current

displayed position. To de-activate the Lock function, press and hold the

key and then momentarily press the

NOTE: The Lock function can also be enabled/disabled through programming.

This allows a more permanent Lock function since programming can be

disabled with a hardware jumper inside the readout thus preventing any front

panel programming changes.

See Section 3: Readout Programming,

Readout Resolution

The Digital readout can be configured to display measurements in any of three

different resolutions.

1. Low– the resolution is

2. Normal– the resolution is:

3. High– the resolution is:

The display of fractions remains the same for all settings: 1/16, 1/32 & 1/64

See Section 3: Readout Programming,

Making Incremental Measurements

The readout has two measurement modes, or indexes. One is referred to as

ABS or Absolute, and the other as INC, or Incremental. The absolute

measurement mode allows the operator to read the current position of the stop

referenced from a fixed or known position such as the saw blade.

The incremental mode allows the operator to make relative distance

measurements from one arbitrary point to another. The absolute position of

the Digi-Stop is not lost when using the incremental mode.

Absolute

The readout automatically enters ABS mode when power is first

applied. This is indicated by the ABS

display. While in the ABS mode, all stop positions are related to the current

ABS, or absolute system reference point, ie the blade..

Incremental

To enter the INC mode, press and hold the

approximately 3 seconds. The INC

of the display. When the INC mode is entered the readout will display zero (0)

or the last offset if one was entered, and may be changed by using the

Accurate Technology DigiStop

key. The word LOCK

UNITS

LOCK is displayed, the +,

LOCK

UNITS

ABS symbol in the upper left corner of the

ABS

INC symbol will appear in the upper left corner

INC

OFF

LOCK

LOCK will appear in the upper left

LOCK

key.

Programming Parameter Pr3.

.1in or .1mm.

.01in or .01mm.

.001in or .01mm

Programming Parameter Pr4.

key and then

and

–

keys

DATUM

key for

UNITS

Page 11 of 16

OFF