Accurate Technology DigiStop-10 Panduan Pemasangan & Pengoperasian - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian untuk Alat Ukur Accurate Technology DigiStop-10. Accurate Technology DigiStop-10 20 halaman. Digi-stop series

Pr11 – Readout Measurement Units
This parameter controls the type of measuring units the Readout displays when
the
key is pressed. The table below illustrates the possible combinations
UNITS
of measuring units that will be displayed by changing this parameter.
Default Value = 0
Pr 11 Setting
Pr12 – Readout Auto-Off Time
This parameter changes the amount of time before the display turns off to
conserve battery power. The value is the number of minutes of idle operation
(no movement or key presses) before the display turns off. When this
parameter is enabled ( 0), pressing the
encoder or system will wake up the Readout.
A value of '0' disables the Auto Off feature (the Readout is always on).
Default Value = 15 (minutes)
Pr13 – Linear Compensation
This parameter invokes a linear multiplier correction in the Readout that is
applied to the actual measurement prior to any offsets. This adjusted
measurement is then displayed on the Readout. This is useful, for instance, if
you would like to display half, double, or other values that can be achieved by
multiplying the actual measurement by the value of the parameter setting.
Use care when enabling this function. It will force the readout to display a value
different from the actual measurement or position.
This Programming Parameter does not apply to all Digi Systems and products.
DO NOT change this value unless instructed to do so by a factory technician!
Default Value = 1.00000
Accurate Technology Digi-Stop
0
1
2
3
4
5
6
············································· [0 to 240]
································ [0.00001 to 9.99999]
·······································
Displayable Units
All inch units and millimeters
Millimeters only
Decimal inches and millimeters
Decimal inches and centimeters
All inch units and centimeters
Centimeters only
Decimal inches only
/
key or movement of the
ON
OFF
[0
to 6]
Page 17 of 20