Arcade ARC13 Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Produk Pipa Arcade ARC13. Arcade ARC13 5 halaman. Single lever bidet mixer with pop up waste

Halaman Cetak

Beautifully

Traditional

Pop-up waste lever

Plug

Vertical control

Plug

Rod extension

adjustment

screw

Control rod link

Plug

housing

Foam

Horizontal control rod

washer

Bidet

Rubber

washer

Body

Ball

Body

washer

ATTENTION

Having ﬁrst checked all new connections, turn on the mains stop cock, close all

taps except the new taps and as the system starts to reﬁll, check for leaks. Once you

have satisﬁed yourself that there are no leaks, switch on the water heating.

Tap Body

Fixing Bolt

Hose

Ball joint retainer

Retainer washer

INSTALLATION INSTRUCTIONS

First shut oﬀ your water heating system, then with your mains stop cock closed, open the

lowest cold and hot taps in the house and allow to run until the cold storage tank and

pipes are empty (the hot storage cylinder always remains full).

Fitting isolating valve to inlet feeds is recommended for ease of maintenance.

INSTALLATION

Note: Remember to turn oﬀ mains water supply before connecting to any existing pipe work.

1: Install the main body:

a) Fit the "O" ring into the groove on the underside of the tap body.

b) Screw the ﬁxing bolt and the ﬂexible hoses into the mixer body, and fully hand tighten.

c) Pass the tail of ﬂexible pipes through the hole on the bidet from above, and place the

mixer in position on the bidet, to see if any alteration to the existing supply pipe work is

necessary. Make any necessary alterations to the pipe work if needed.

"O" Ring

d) Tighten the rubber washer, the brass washer with the ﬁxing nut from the under-side

of the bidet. Check that the mixer body is correctly positioned, fully tighten the ﬁxing nut .

e) Connect the water supply pipes to the tails of the ﬂexible hoses for the hot water and cold water.

Rubber Washer

2: Pop-up waste

Brass Washer

a) Insert the pop-up waste lever into the slot at the back of the mixer body.

Fixing Nut

b) From the underside of the bidet screw the pop-up waste lever into the control rod extension.

Spanner

c) Assemble the pop-up waste to the bidet, with the foam washer on top and the

below and hand tighten.

d) Push the body washer into the body of the pop-up waste, prepare the horizontal control rod

by sliding on the retainer washer and ball joint retainer making sure the cup part of the

retainer washer will sit around the ball. Slide the control rod link onto the vertical control

rod and then onto the horizontal control rod.

e) Insert the short end (with ball) of the horizontal control rod into the body (the horizontal

control rod can be slid through the control rod link) and clamp to the body with the ball

joint retainer. Do not over tighten.

f) Test the action of the pop-up waste and fully tighten the control rod link. Adjust the ball

joint retainer if required.

Arcade single lever bidet mixer

with pop up waste

www.arcadebathrooms.com

ARC13, ARC13 CHR

washer

rubber