ABB ControlMaster CM10 Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk untuk Pengontrol ABB ControlMaster CM10. ABB ControlMaster CM10 4 halaman.

Halaman Cetak

6 Icons

6.1 Creating a new configuration

1. Select the New icon.

2. Select the product that you wish to configure from the

displayed options and click OK.

3. Select the required Build Options and click OK.

The configuration window is displayed.

6.2 Opening an existing configuration

1. Select the Open icon.

2. Navigate to the required location and select the

configuration file you wish to open.

Click the Open button to open the file and load the

Configuration window.

6.3 Saving a configuration file with existing filename

1. Select the Save icon to save an open configuration file with

the same file name.

6.4 Saving a configuration file with a new filename

1. Select the Save As icon to save an open configuration file

with a different filename.

2. Navigate to the required storage location and enter the

required filename.

3. Click on the Save button to save the file with the new file

name.

6.5 Reading a configuration from a connected device

1. Ensure the USB IrDA adaptor is plugged into the PC.

2. On the instrument, press either the left hand or right hand

key to display the Access Level page.

3. Select Advanced (enter any password required).

4. Select the Device Setup page.

5. Use the up / down keys to select IrDA configuration.

6. Highlight Connect and press Select to show the

following screen:

Connect

Begin PC Read/Write

Disconnected

Exit

7. Align the USB IrDA adaptor with the instrument to establish

a connection. When a connection is established the

icon on the bottom left hand corner of the application

window turns green and the Connected device box is

populated as shown in Fig. 11.1.

Fig. 11.1 Connected device box showing connection established

ControlMaster controllers and indicators | ConfigPilot Creating, uploading and downloading configurations | IN/RandC/003–EN Rev.A

8. Select the Read icon.

. If the configuration is already open, a warning dialog

Note

is displayed to indicate the existing configuration will be

overwritten – a warning

9. Select Yes to continue or No to abort the read.

10. If Yes is selected the configuration is read from the

instrument to the application.

11. An information dialog is displayed to indicate a successful

or unsuccessful read.

6.6 Writing a configuration to a connected device

1. Ensure the USB IrDA adaptor is plugged into the PC.

2. On the instrument, press either the left hand or right hand

key to display the Access Level page.

3. Select Advanced (enter any password required).

4. Select the Device Setup page.

5. Use the up / down keys to select IrDA configuration.

6. Highlight Connect and press Select to show the

following screen:

Connect

Begin PC Read/Write

Disconnected

Exit

7. Align the USB IrDA adaptor with the instrument to establish

a connection. When a connection is established the

Connected icon on the bottom left hand corner of the

application window will turn green and the Connected

device box is populated as shown in Fig. 11.1.

8. Select the Write icon.

. A warning dialog is displayed to indicate the existing

Note

configuration will be overwritten.

9. Select Yes to continue or No to abort the read.

10. If Yes is selected the configuration is written from the

application to the instrument.

11. An information dialog is displayed to indicate a successful

or unsuccessful write.

. If the instrument build and the configuration build

Note

selected do not match, a warning dialog is displayed and

an option is provided to continue or abort the write.

displayed on first read.

is not