AXTON AE402C Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penerima Mobil AXTON AE402C. AXTON AE402C 17 halaman. 2-way component systems

TWEETER INSTALLATION

There are two ways to install the tweeters of this component set: Surface or fully recessed

mounting.

Flat Surface Mounting

Disassemble the angled surface mount adaptor.

Mark and drill holes where you want to x the tweeters. You can use the base cap directly

as a template. Three holes need to be drilled, one main hole for the cable routing and two

small pilot holes for xing the base to the surface. You'll need 2.5 mm and 6 mm drill bits

and a power drill. After drilling the holes, mount the at base cap to the surface, using the

two self tapping screws contained in the accessory set. Feed the tweeter wire through the

center hole and connect the tweeter extension wire from the crossovere to the tweeter.

Place the upper ring shaped adapter over the tweeter and press down to lock it in place.

Recessed Tweeter Mounting

After choosing a mounting location with at least 19.5 mm clearance behind the panel,

the tweeter must be disassembled to nd the best mounting location. Pre-drill small pilot

holes on the driver and passenger sides where the tweeters shall be mounted. The pilot

holes must now be enlarged to 46.5 mm diameter with a core drill. Reassemble the main

tweeter unit into the recessed mounting adaptor. Insert the tweeter assembly into the hole

you have cut. Use the toothed ring to x the tweeter in place by pushing the toothed ring

over the backside of the mounting adaptor. You can now connect the tweeter extension

wire to the wire coming from the crossover. Remount the panels, you're done.

– 5 –