AXTON AE402C Installation Manual - Page 5
Browse online or download pdf Installation Manual for Car Receiver AXTON AE402C. AXTON AE402C 17 pages. 2-way component systems
Print PageTWEETER INSTALLATION
There are two ways to install the tweeters of this component set: Surface or fully recessed
mounting.
Flat Surface Mounting
Disassemble the angled surface mount adaptor.
Mark and drill holes where you want to x the tweeters. You can use the base cap directly
as a template. Three holes need to be drilled, one main hole for the cable routing and two
small pilot holes for xing the base to the surface. You'll need 2.5 mm and 6 mm drill bits
and a power drill. After drilling the holes, mount the at base cap to the surface, using the
two self tapping screws contained in the accessory set. Feed the tweeter wire through the
center hole and connect the tweeter extension wire from the crossovere to the tweeter.
Place the upper ring shaped adapter over the tweeter and press down to lock it in place.
Recessed Tweeter Mounting
After choosing a mounting location with at least 19.5 mm clearance behind the panel,
the tweeter must be disassembled to nd the best mounting location. Pre-drill small pilot
holes on the driver and passenger sides where the tweeters shall be mounted. The pilot
holes must now be enlarged to 46.5 mm diameter with a core drill. Reassemble the main
tweeter unit into the recessed mounting adaptor. Insert the tweeter assembly into the hole
you have cut. Use the toothed ring to x the tweeter in place by pushing the toothed ring
over the backside of the mounting adaptor. You can now connect the tweeter extension
wire to the wire coming from the crossover. Remount the panels, you're done.
– 5 –