ABB EBN861 Instruksi - Halaman 12
Jelajahi secara online atau unduh pdf Instruksi untuk Pengontrol ABB EBN861. ABB EBN861 18 halaman. Power electronic units for field installation. for the control of contrac actuators of the pme, lme, rhd or rsd series
Juga untuk ABB EBN861: Petunjuk Manual (17 halaman)
Halaman Cetak
9.3
Example for signal input / output
(conventional analogue / binary control)
Procede as follows to switch the actuator into automatic mode (AUT):
- activate digital inputs D1, D2, and D3 using the configuration software (standard configuration with
default factory settings).
- activate the AUT mode using the configuration software (standard configuration with default factory
settings).
9.3.1
Standard wiring (analogue setpoint)
+ Y
1
2
3
+ -
+ -
Fig. 10:
9.3.2
Behind a step controller
(binary control without an analogue setpoint)
Contrac actuators feature smooth and continous operation even if the elctronic unit receives binary
commands from a step controller. Use the configuration software for the appropriate settings. The elec-
tronic unit will then integrate the step commands and internally generate an analogue setpoint signal.
.
+ Y
1
2
+ -
Fig. 11:
9.4
Connecting the cable shield
Fig. 12: Connecting the cable shield of EAN823; EBN853; EBN861
Connect the screen at the actuator accordingly.
12
AUT
MAN
- Y
5
8
9 10
11
4
6
7
+ -
- Y
5
3
6
8
9 10
4
7
+ -
+ -
3
1
4
26
27
12
13
14
15
+ -
-
+
RB
24V
+ -
26
27
11
12
13
14
15
+ -
-
+
RB
24V
+ -
4
3
2
1
r00331x1
28
29
30
31
+
-
RB
+
I
+ -
Uv
U
24V
28
29
30
31
+
-
RB
+
I
+ -
Uv
U
24V
- Remove approximately 2 cm of the
cable sheathing (1) at the cable entry
of the housing (4).
- Open the cable shield in this area
and fold it back over the cable
sheathing (1).
- Insert the cable end in the cable entry
and fasten it with the clamp; make
sure that the shield is folded back
and in contact with the clamp and
the electronics housing.
r00358x1
r00359x1