Axxess AX-TYAMP1-SWC Panduan Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Penguat Axxess AX-TYAMP1-SWC. Axxess AX-TYAMP1-SWC 8 halaman. Lexus/toyota amp interface with swc 2002-2015

Halaman Cetak

Initializing the AX-TYAMP1-SWC

For the steps below, the Red L.E.D. (located inside the interface, next to the

potentiometer) can only be seen while active. The interface does not need to be

opened to see the L.E.D.

• Turn the key (or push-to-start button) to the ignition position, the L.E.D. will turn on.

• Within a minute, the L.E.D. will turn off for a couple seconds, then flash slowly (up

to (16) times, indicating which radio is connected to the interface), and then turn

off. Pay close attention as to how many slow flashes there are. This will help in

troubleshooting, if need be. Refer to the L.E.D. feedback section for more information.

• Within a few seconds the L.E.D. will turn on, and the radio will turn off.

• Within a minute the L.E.D. will turn off, and the radio will come back on, indicating the

initialization process was successful. The factory amplifier should come on and you

should hear sound at this point.

Note: If the radio does not come back on within a minute, the interface is not

communicating to the vehicle. Turn the key off, check all connections, and then try

again. The interface may need to be reset at this point.

•

Test all functions of the installation for proper operation, before reassembling the dash.

Note: Fade control will not be retained with this interface.

AX-TYAMP1-SWC

Adjusting the AX-TYAMP1-SWC

Audio level adjustment

• With the vehicle and radio turned on, turn the volume up 3/4 of the way.

• With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise

the audio level; counterclockwise to lower the audio level.

• Once at a desired level, audio level adjustment is complete.