Axxess AX-TYAMP1-SWC Handleiding voor installatie-instructies - Pagina 4
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Axxess AX-TYAMP1-SWC. Axxess AX-TYAMP1-SWC 8 pagina's. Lexus/toyota amp interface with swc 2002-2015
Pagina afdrukkenInitializing the AX-TYAMP1-SWC
For the steps below, the Red L.E.D. (located inside the interface, next to the
potentiometer) can only be seen while active. The interface does not need to be
opened to see the L.E.D.
• Turn the key (or push-to-start button) to the ignition position, the L.E.D. will turn on.
• Within a minute, the L.E.D. will turn off for a couple seconds, then flash slowly (up
to (16) times, indicating which radio is connected to the interface), and then turn
off. Pay close attention as to how many slow flashes there are. This will help in
troubleshooting, if need be. Refer to the L.E.D. feedback section for more information.
• Within a few seconds the L.E.D. will turn on, and the radio will turn off.
• Within a minute the L.E.D. will turn off, and the radio will come back on, indicating the
initialization process was successful. The factory amplifier should come on and you
should hear sound at this point.
Note: If the radio does not come back on within a minute, the interface is not
communicating to the vehicle. Turn the key off, check all connections, and then try
again. The interface may need to be reset at this point.
•
Test all functions of the installation for proper operation, before reassembling the dash.
Note: Fade control will not be retained with this interface.
®
AX-TYAMP1-SWC
Adjusting the AX-TYAMP1-SWC
Audio level adjustment
• With the vehicle and radio turned on, turn the volume up 3/4 of the way.
• With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise
the audio level; counterclockwise to lower the audio level.
• Once at a desired level, audio level adjustment is complete.