Axxess AX-DSP Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kabel dan konektor Axxess AX-DSP. Axxess AX-DSP 10 halaman. Axxess digital signal processor

Halaman Cetak

Pin 1 - RED - Accessory 12-volt

• Connect this wire to 12-volt accessory that comes on when the key is in the run position.

Note: If your vehicle does not have an accessory wire at the radio, cap off and disregard the wire.

Pin 2 - BROWN - Not in use

Pin 3 - PINK - CAN High (CAN +)

• This wire is connected to the CAN Bus wire in the radio connector. Consult the vehicle specific

manual to the wire locations. (All CAN Bus wires must be soldered)

Pin 4 - BLACK/YELLOW - Future use, do not connect

Pin 5 - WHITE/BLACK - Front Left Speaker (-)

• Connect to the front left signal wire from the OE radio to this wire.

Pin 6 - GREY/BLACK - Front Right Speaker (-)

• Connect to the front right signal wire from the OE radio to this wire.

Pin 7 - GREEN/BLACK - Rear Left Speaker (-)

• Connect to the rear left signal wire from the OE radio to this wire.

Pin 8 - PURPLE/BLACK - Rear Right Speaker (-)

• Connect to the rear right signal wire from the OE radio to this wire.

Pins 9 & 19 - RCA Input 5

• Alert input that is required on some Ford models, installation manual will reference when required.

In aftermarket applications, this will be the subwoofer input from your aftermarket radio.

Pins 10 & 20 - RCA Input 6

• TBD

Pin 11 - YELLOW - Constant 12-volt Supply

• Connect to the 12-volt constant wire in the radio harness.

WIRE DESCRIPTION

(20-PIN MICROFIT)

Pin 12 - ORANGE - Control Wire for AX-BASSKNOB

• This wire gets connected to the Orange wire

of the AX-BASSKNOB, this is an optional

accessory (sold separately) and allows

external control of the subwoofer level.

Pin 13 - BLUE/PINK - CAN Low (CAN -)

• This wire is connected to the CAN Bus wire

in the radio connector. Consult the vehicle

specific manual to the wire locations. All CAN

Bus wires should be soldered.

Pin 14 - BLACK - Ground

• This wire gets connected to the ground wire

in the factory radio harness.

Pin 15 - WHITE- Front Left Speaker (+)

• Connect to the front left signal wire from the

OE radio to this wire.

Pin 16 - GREY- Front Right Speaker (+)

• Connect to the front right signal wire from the OE radio to this wire.

Pin 17 - GREEN- Rear Left Speaker (+)

• Connect to the rear left signal wire from the OE radio to this wire.

Pin 18 - PURPLE- Rear Right Speaker (+)

• Connect to the rear right signal wire from the OE radio to this wire.

20-pin Microfit

REV. 8/10/2017 INSTAX-DSP