Axxess AX-DSP Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kable i złącza Axxess AX-DSP. Axxess AX-DSP 10 stron. Axxess digital signal processor
Drukuj stronęPin 1 - RED - Accessory 12-volt
• Connect this wire to 12-volt accessory that comes on when the key is in the run position.
Note: If your vehicle does not have an accessory wire at the radio, cap off and disregard the wire.
Pin 2 - BROWN - Not in use
Pin 3 - PINK - CAN High (CAN +)
• This wire is connected to the CAN Bus wire in the radio connector. Consult the vehicle specific
manual to the wire locations. (All CAN Bus wires must be soldered)
Pin 4 - BLACK/YELLOW - Future use, do not connect
Pin 5 - WHITE/BLACK - Front Left Speaker (-)
• Connect to the front left signal wire from the OE radio to this wire.
Pin 6 - GREY/BLACK - Front Right Speaker (-)
• Connect to the front right signal wire from the OE radio to this wire.
Pin 7 - GREEN/BLACK - Rear Left Speaker (-)
• Connect to the rear left signal wire from the OE radio to this wire.
Pin 8 - PURPLE/BLACK - Rear Right Speaker (-)
• Connect to the rear right signal wire from the OE radio to this wire.
Pins 9 & 19 - RCA Input 5
• Alert input that is required on some Ford models, installation manual will reference when required.
In aftermarket applications, this will be the subwoofer input from your aftermarket radio.
Pins 10 & 20 - RCA Input 6
• TBD
Pin 11 - YELLOW - Constant 12-volt Supply
• Connect to the 12-volt constant wire in the radio harness.
WIRE DESCRIPTION
(20-PIN MICROFIT)
Pin 12 - ORANGE - Control Wire for AX-BASSKNOB
• This wire gets connected to the Orange wire
of the AX-BASSKNOB, this is an optional
accessory (sold separately) and allows
external control of the subwoofer level.
Pin 13 - BLUE/PINK - CAN Low (CAN -)
• This wire is connected to the CAN Bus wire
in the radio connector. Consult the vehicle
specific manual to the wire locations. All CAN
Bus wires should be soldered.
Pin 14 - BLACK - Ground
• This wire gets connected to the ground wire
in the factory radio harness.
Pin 15 - WHITE- Front Left Speaker (+)
• Connect to the front left signal wire from the
OE radio to this wire.
Pin 16 - GREY- Front Right Speaker (+)
• Connect to the front right signal wire from the OE radio to this wire.
Pin 17 - GREEN- Rear Left Speaker (+)
• Connect to the rear left signal wire from the OE radio to this wire.
Pin 18 - PURPLE- Rear Right Speaker (+)
• Connect to the rear right signal wire from the OE radio to this wire.
20-pin Microfit
REV. 8/10/2017 INSTAX-DSP
3