Epson AcuLaser C2000 Setup Manual - Halaman 29
Jelajahi secara online atau unduh pdf Setup Manual untuk Printer Epson AcuLaser C2000. Epson AcuLaser C2000 46 halaman. Color laser printer
Juga untuk Epson AcuLaser C2000: Referensi Cepat (29 halaman), Panduan Membongkar Kemasan (21 halaman), Referensi Cepat (29 halaman)
Halaman Cetak
To confirm that the Hard Disk Drive is installed correctly, print a
status sheet. If the drive is not listed on the status sheet, try
reinstalling. Make sure that the electronic connector on the Hard
Disk Drive is securely connected to the socket on the circuit board.
For instructions on how to print a status sheet, see "Printing a
status sheet" on page 37.
Installing a Memory Module
Increasing the printer's memory allows you to print complex and
graphics-intensive documents. You can increase printer memory
up to 512 MB by installing optional Dual In-line Memory Modules
(DIMMs).
This printer has two DIMM slots, but one slot has a 32 MB DIMM
already installed in it at the time of manufacture. To increase
printer memory to its maximum of 512 MB, you have to purchase
two 256 MB DIMMs and remove the original 32 MB DIMM.
You can purchase DIMMs from various vendors. Be sure they
meet the following requirements:
DRAM type
Memory size
Type
Access speed
Height
* SPD stands for Serial Presence Detect, a chip residing on the memory module
that contains information about the size, speed, and other specifications of
the memory as well as manufacturer information that can be retrieved by
the motherboard through electronic signals.
Synchronous Dynamic RAM Dual In-line
Memory Module (SDRAM DIMM)
32 MB, 64 MB, 128 MB, or 256 MB
168-pin type, 64 bit, with SPD*
66.66 MHz or higher (15 ns or less)
Less than 40 mm
Installing the Options
28