Epson AcuLaser C2000 Instrukcja konfiguracji - Strona 29

Przeglądaj online lub pobierz pdf Instrukcja konfiguracji dla Drukarka Epson AcuLaser C2000. Epson AcuLaser C2000 46 stron. Color laser printer
Również dla Epson AcuLaser C2000: Skrócona instrukcja obsługi (29 strony), Instrukcja rozpakowywania (21 strony), Skrócona instrukcja obsługi (29 strony)

To confirm that the Hard Disk Drive is installed correctly, print a

status sheet. If the drive is not listed on the status sheet, try

reinstalling. Make sure that the electronic connector on the Hard

Disk Drive is securely connected to the socket on the circuit board.

For instructions on how to print a status sheet, see "Printing a

status sheet" on page 37.

Installing a Memory Module

Increasing the printer's memory allows you to print complex and

graphics-intensive documents. You can increase printer memory

up to 512 MB by installing optional Dual In-line Memory Modules

(DIMMs).

This printer has two DIMM slots, but one slot has a 32 MB DIMM

already installed in it at the time of manufacture. To increase

printer memory to its maximum of 512 MB, you have to purchase

two 256 MB DIMMs and remove the original 32 MB DIMM.

You can purchase DIMMs from various vendors. Be sure they

meet the following requirements:

DRAM type

Memory size

Type

Access speed

Height

* SPD stands for Serial Presence Detect, a chip residing on the memory module

that contains information about the size, speed, and other specifications of

the memory as well as manufacturer information that can be retrieved by

the motherboard through electronic signals.

Synchronous Dynamic RAM Dual In-line

Memory Module (SDRAM DIMM)

32 MB, 64 MB, 128 MB, or 256 MB

168-pin type, 64 bit, with SPD*

66.66 MHz or higher (15 ns or less)

Less than 40 mm

Installing the Options