Ayra ITA3D 710 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Pencahayaan Ayra ITA3D 710. Ayra ITA3D 710 9 halaman. Rgb dmx laser with 3d effect

Halaman Cetak

Working mode explanation:

Sound active:

The unit uses its internal microphone to sense music (the beat of the music) and will change patterns

according to the beat of the music. The microphone is situated at the front of the laser device. On the

rear of the laser, there is an adjustable microphone sensitivity knob.

Please note that the sound-activated mode will not function properly when the music source is not loud

enough or when only high-pitched sounds are played.

Auto-beam:

The laser device will activate a pre-defined lasershow on a solid speed setting. The patterns are

mainly beam-effects.

Auto-animation:

The laser device will activate a pre-defined lasershow on a solid speed setting. The patterns are

mainly animations and graphics.

Slave mode:

It is possible to link several ITA3D 710 fixtures for a synchronized lasershow, without the use of a

DMX controller.

Connect your devices with standard XLR-XLR cables. The first device in the chain needs to be set to a

basic function, such as sound-active or one of the auto shows.

Select the slave mode on all other connected device in the chain. You will notice that these devices

will mimic the actions of the first device.

DMX mode:

With an external DMX-controller (or DMX-software) it is possible to control every feature of the laser

device. It is possible to adjust the built-in patterns and to add several effects, such as zoom-effects or

pattern rotation.

NOTE: When the DMX-signal or master/slave signal is lost (due to a failure in the DMX-connection or

any other reason), the laser will shut off the output due to safety issues. This prevents the projection of

static images and/or patterns.