Digikeijs DR5033 Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pemanjang Digikeijs DR5033. Digikeijs DR5033 18 halaman. 3-ampere, h-bridge dcc booster
Juga untuk Digikeijs DR5033: Manual (10 halaman), Buku Petunjuk (18 halaman)

Halaman Cetak

DR5033 DIGIBOOST

Stand 2021-07-06

2.3 Hardware Overview

1 CDE Booster connection

(Please check whether the CDE connection of your control panel com-

plies with the requirements specified by Lenz®).

2 LocoNet® B Connector 1

3 LocoNet® B Connector 2

4 Tack Sniffer Input

By connecting the Track Sniffer input to the track output of the central unit, the track

signal is recognized even if none of the other input options are available.

(CDE Booster connection, LocoNet® B, Roco® B Bus) can be used on the DR5033.

5 Roco® Booster Bus Connector 1

6 Roco® Booster Bus Connector 2

power supply

DC 15-19V 3,5A

8 Track Output

9 Booster Status LED

Track signal present (normal operation)

No track signal present.

(Loconet® B, B-Bus, CDE, Track Sniffer Input)

Booster load under 90%.

(LED becomes brighter under load)

Booster load greater than 90%.

Short circuit detected

Stop command detected (e.g. by the control unit)

Track Out reversed polarity.

Note:

If the blue LED lights up when driving over the booster separation

points, the track output of the DR5033 is connected with reversed polarity.

www.digikeijs.com

® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz

P 5