Digikeijs DR5033 Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Extensor Digikeijs DR5033. Digikeijs DR5033 18 páginas. 3-ampere, h-bridge dcc booster
También para Digikeijs DR5033: Manual (10 páginas), Manual de instrucciones (18 páginas)
Imprimir página
DR5033 DIGIBOOST
Stand 2021-07-06
2.3 Hardware Overview
1 CDE Booster connection
(Please check whether the CDE connection of your control panel com-
plies with the requirements specified by Lenz®).
2 LocoNet® B Connector 1
3 LocoNet® B Connector 2
4 Tack Sniffer Input
By connecting the Track Sniffer input to the track output of the central unit, the track
signal is recognized even if none of the other input options are available.
(CDE Booster connection, LocoNet® B, Roco® B Bus) can be used on the DR5033.
5 Roco® Booster Bus Connector 1
6 Roco® Booster Bus Connector 2
7
power supply
DC 15-19V 3,5A
8 Track Output
9 Booster Status LED
Track signal present (normal operation)
No track signal present.
(Loconet® B, B-Bus, CDE, Track Sniffer Input)
Booster load under 90%.
(LED becomes brighter under load)
Booster load greater than 90%.
Short circuit detected
Stop command detected (e.g. by the control unit)
Track Out reversed polarity.
Note:
If the blue LED lights up when driving over the booster separation
points, the track output of the DR5033 is connected with reversed polarity.
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
1
2
3
4
5
7
8
6
9
P 5