Digilin SGM-530 Panduan Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Lampu Kerja Digilin SGM-530. Digilin SGM-530 2 halaman. Led highbay
Halaman Cetak
Sigma - LED Highbay
Installation Guide
Surface Mount – Rear Entry
1.
Cut appropriate hole for Cable
entry
Angle Mount
1.
Loosen angle bracket
4.
Adjust fitting to desired angle
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
digilin.com.au
+617 3899 1267
2.
Connect mains power to fitting.
Where applicable connect control
signals.
2.
Mount Fitting to desired location. Ensure method
of mounting & all materials used are of
appropriate weight rating.
5.
Tighten angle bracket bolts
3.
Mount the fitting to desired location.
Ensure method of mounting & all materials
used are of appropriate weight rating. Do
not use the power cable to support the
weight of the fitting.
3.
Connect power cable and any
appropriate control cables
6.
Power on and test fitting
4.
Power on
and Test
www.digilin.com.au
Page 2 of 2