Digilock Curve Keypad Basic Instal Manual - Halaman 8

Jelajahi secara online atau unduh pdf Instal Manual untuk Sistem Rfid Digilock Curve Keypad Basic. Digilock Curve Keypad Basic 13 halaman. Deadlatch/deadbolt motorized rear

Halaman Cetak

LOCK INSTALLATION STEPS

For illustration, a keypad front unit with a bolt rear unit is shown�

ATTENTION:

The rear-unit connector must be oriented with the

ribbon cable (as highlighted in fig-1). Improper connection may result in the lock to improperly function.

With the cable connector properly oriented. Insert the rear units

cable connector to the corresponding front units pin-connector

(as highlighted in fig-1).

Front View

Insert the front units nut-post through the doors mounting holes.

Hold and align the rear-unit using the same mounting holes

Note:

To avoid pinching of the ribbon cable a recessed pocket is

provided behind the rear unit.

Rear View

Test the lock while the door is open to ensure that the bolt or latch is operating properly. Refer to the testing instructions below.

Once installation is complete, refer to the DigiLink Site Setup Guide to add locks.

I NSTALL GU ID E

Keypad & RFID | Basic & Advanced

red wire

fig-1

The LED will flash red 3 times accompanied with a three-tone

beep, then followed by the LED flashing green 3 times.

Note:

The audible/visual feedback may only indicate that the

metal pin's have made contact. It is necessary to further insure

that both connectors are properly seated and connected

(as highlighted in fig-2).

Use the screw chart

to select the proper

screw length for your

door thickness.

Insert the screw with lock-washer through the mounting holes.

Tighten screws to the torque level of:

Note:

Overtightening of the mounting hardware may result in

the lock to improperly function.

positioned on the top of the

21.4 kgf/cm² ±20%

fig-2

Rear View

Front View