Cresco 10SW Manual - Halaman 6

Jelajahi secara online atau unduh pdf Manual untuk Penyebar Cresco 10SW. Cresco 10SW 15 halaman. Fertilizer and salt spreader
Juga untuk Cresco 10SW: Manual (6 halaman)

Halaman Cetak

Assembling your Cresco 10

Feed the other end of the

control rod (item 15) through the

hole of the control lever (17).

Make sure you push the control

lever all the way to setting 20.

Do not tighten into place.

Affix the agitator pin (Item 8)

through the impellor shaft inside

the hopper.

FINAL TOUCHES:

IMPORTANT

Summer slider pictured

Before tightening the control

rod. Make sure the application

holes in the hopper are fully

open and the control lever is

set at 20.

With the hopper aperture fully

open (as in figure 13) and the

gauge lever set at 20, tighten

the screw firmly to secure the

control rod.