Cisco 2950 - Catalyst Switch Manual - Halaman 3

Jelajahi secara online atau unduh pdf Manual untuk Beralih Cisco 2950 - Catalyst Switch. Cisco 2950 - Catalyst Switch 19 halaman. Long-reach ethernet switches
Juga untuk Cisco 2950 - Catalyst Switch: Panduan Solusi (17 halaman), Buletin Produk (3 halaman), Buletin Dukungan Produk (5 halaman), Panduan Migrasi (25 halaman), Buletin Dukungan Produk (6 halaman), Panduan Memulai (29 halaman), Lembar data (20 halaman)

Cisco - Connecting a Terminal to the Console Port on Catalyst Switches

need to provide an RJ-45-to-DB-25 female data terminal equipment (DTE) adapter if you want to

connect the switch console port to a terminal. You may order a kit (part number ACS-DSBUASYN=)

containing the adapter from Cisco. The PC or terminal must support VT100 terminal emulation. The

terminal emulation softwarefrequently a PC application such as Hyperterminal or Procomm Plusmakes

communication between the switch and your PC or terminal possible during the setup program.

Follow these steps to connect the PC or terminal to the switch:

Be sure that your PC or terminal emulation software is configured to communicate with the switch

via hardware flow control.

Configure the baud rate and character format of the PC or terminal to match these console port

default characteristics:

9600 baud

8 data bits

1 stop bit

No parity

Using the supplied rollover cable, insert the RJ-45 connector into the console port.

Attach the supplied RJ-45-to-DB-9 female DTE adapter to a PC, or attach an appropriate adapter

to the terminal.

Insert the other end of the supplied rollover cable in the attached adapter.

Run the terminal emulation program if you are using a PC or a terminal.

Table A-1: Console Port Signaling and Cabling Using a DB-9 Adapter

Console

RJ-45-to-RJ-45

Port

Rollover Cable

(DTE)

RJ-45

Signal

RTS

http://www.cisco.com/warp/public/473/9.html (3 of 19) [9/4/2003 12:36:02 PM]

RJ-45-to-DB-9

Terminal

Adapter

RJ-45

DB-9 Pin

Console

Device

Signal

CTS