Cisco Aironet 350 Series Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Beralih Cisco Aironet 350 Series. Cisco Aironet 350 Series 10 halaman. Managed switches
Juga untuk Cisco Aironet 350 Series: Panduan Memulai Cepat (12 halaman), Catatan Rilis (14 halaman), Panduan Memulai Cepat (16 halaman), Panduan Memulai Cepat (12 halaman), Panduan Memulai Cepat (12 halaman), Panduan Memulai Cepat (2 halaman), Mengenal (16 halaman), Panduan Memulai Cepat (5 halaman)

The available commands may vary depending on the exact model of your device. In this example,

CBS350-48MP switch is used.The hostname of the Standby switch is CBS350-2.

Step 2

Enter the Global Configuration mode of the switch by entering the following:

configure

CBS350-1#

Step 3

To enter the context of the specified stack unit or all stack units, enter the stack unit command in

the Global Configuration mode by entering the following:

stack unit [unit-id | all]

CBS350-1(config)#

Step 4

Enter the stack configuration command to configure the stack ports and unit ID after reboot by

entering the following:

stack configuration {[links ports-list] [unit-id | auto]}

CBS350-1(unit)#

The options are:

ports-list - a list of one or more stack ports separated by comma, or a range of sequential

ports marked by dash.

links - Choose port list to be used as stack links after reload.

unit-id - Choose the unit ID to be used after reload. The range is 1 to 4. You can use auto to

enable stack auto numbering feature.

Step 5 (Optional)

To remove stack configuration settings on the switch, use the no stack configuration command by

entering the following:

no stack configuration

CBS350-1(unit)#

Step 6

Enter the end command to go back to the Privileged EXEC mode of the switch.

end

CBS350-1(unit)#

Step 7 (Optional)

To display the stack configuration settings, enter the following: