Cisco Aironet 350 Series 매뉴얼 - 페이지 5

{카테고리_이름} Cisco Aironet 350 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 350 Series 10 페이지. Managed switches
Cisco Aironet 350 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (12 페이지), 릴리스 정보 (14 페이지), 빠른 시작 매뉴얼 (16 페이지), 빠른 시작 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (2 페이지), 자세히 알아보기 (16 페이지), 빠른 시작 매뉴얼 (5 페이지)

The available commands may vary depending on the exact model of your device. In this example,

CBS350-48MP switch is used.The hostname of the Standby switch is CBS350-2.

Step 2

Enter the Global Configuration mode of the switch by entering the following:

configure

CBS350-1#

Step 3

To enter the context of the specified stack unit or all stack units, enter the stack unit command in

the Global Configuration mode by entering the following:

stack unit [unit-id | all]

CBS350-1(config)#

Step 4

Enter the stack configuration command to configure the stack ports and unit ID after reboot by

entering the following:

stack configuration {[links ports-list] [unit-id | auto]}

CBS350-1(unit)#

The options are:

ports-list - a list of one or more stack ports separated by comma, or a range of sequential

ports marked by dash.

links - Choose port list to be used as stack links after reload.

unit-id - Choose the unit ID to be used after reload. The range is 1 to 4. You can use auto to

enable stack auto numbering feature.

Step 5 (Optional)

To remove stack configuration settings on the switch, use the no stack configuration command by

entering the following:

no stack configuration

CBS350-1(unit)#

Step 6

Enter the end command to go back to the Privileged EXEC mode of the switch.

end

CBS350-1(unit)#

Step 7 (Optional)

To display the stack configuration settings, enter the following: