Cisco ASR 900 Series Panduan Konfigurasi - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Beralih Cisco ASR 900 Series. Cisco ASR 900 Series 19 halaman. Configuring 1g traffic on 8-port 10 gigabit
ethernet interface module
Juga untuk Cisco ASR 900 Series: Panduan Konfigurasi (13 halaman), Panduan Konfigurasi (6 halaman), Panduan Konfigurasi (6 halaman)
Halaman Cetak
Command or Action
Step 2
configure terminal
Example:
Device# configure terminal
Step 3
interface type number [name-tag]
Example:
Step 4
no cdp enable
Example:
Device(config-if)# no cdp enable
Step 5
end
Example:
Device(config-if)# end
Example
In the following example, Cisco Discovery Protocol is first disabled on an interface:
Device(config)#
Device(config-if)# no ip address
Device(config-if)# shutdown
Device(config-if)# no cdp enable
! Cisco Discovery Protocol is disabled.
Device(config-if)# end
Enabling Cisco Discovery Protocol on a Supported Interface
If the encapsulation of an interface is changed, Cisco Discovery Protocol is reenabled on that interface,
Note
even if Cisco Discovery Protocol was previously disabled.
Procedure
Command or Action
Step 1
enable
8
Purpose
Enters global configuration mode.
Configures the specified interface and enters interface
configuration mode.
Disables Cisco Discovery Protocol on the interface.
If the encapsulation of an interface is changed, Cisco
Note
Discovery Protocol is reenabled on that interface even if
Cisco Discovery Protocol was previously disabled.
Exits to privileged EXEC mode.
Purpose
Enables privileged EXEC mode.