Digiprog III Panduan Pengenalan

Jelajahi secara online atau unduh pdf Panduan Pengenalan untuk Aksesori Mobil Digiprog III. Digiprog III 10 halaman. Mileage correction tool

Digiprog Ltd.

www.digiprog.com

Introduction to DigiProg III

Powering up your DigiProg.

A regulated 12 volt power supply should be used to power your

DigiProg III. If anything above 13.5 volts is used to power the machine,

damage may be caused to the main circuit board and it will need to be

sent to your DigiProg dealer for repair.

When connected to a vehicle by OBD

DO NOT

use the cigar lighter lead,

the Digi takes power from the vehicle. Failure to observe will result in

damage not covered by the warranty.

When your DigiProg is powered up, this screen will be displayed whilst

your machine is loading:

On this screen your DigiProg's status/software version is displayed

along with your machines unique 12 digit electronic serial number.

INTRODUCTION

Page 1