自動車アクセサリー Digiprog IIIのPDF 導入マニュアルをオンラインで閲覧またはダウンロードできます。Digiprog III 10 ページ。 Mileage correction tool
ページを印刷する
Digiprog Ltd.
www.digiprog.com
Introduction to DigiProg III
Powering up your DigiProg.
A regulated 12 volt power supply should be used to power your
DigiProg III. If anything above 13.5 volts is used to power the machine,
damage may be caused to the main circuit board and it will need to be
sent to your DigiProg dealer for repair.
When connected to a vehicle by OBD
DO NOT
use the cigar lighter lead,
the Digi takes power from the vehicle. Failure to observe will result in
damage not covered by the warranty.
When your DigiProg is powered up, this screen will be displayed whilst
your machine is loading:
On this screen your DigiProg's status/software version is displayed
along with your machines unique 12 digit electronic serial number.
© 2007 by DigiProg Ltd
INTRODUCTION
Page 1