Digisol DG-GS4628FSE2 Panduan Instalasi - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Beralih Digisol DG-GS4628FSE2. Digisol DG-GS4628FSE2 20 halaman. Giga layer 3 switches

transceiver's TX port should be connected to the RX port of the corresponding device, and

vice versa.

Step 3: Check the fiber port status indicator, a lighted LED indicates that the link has been

established; otherwise the link is not ready and should be examined.

Caution!

Please verify the sign above the port to ensure using the other ports. Connecting to wrong

ports might damage the transceiver or the other ports. When connecting other devices

through a fiber cable to the switch, the output power of the fiber cable must not exceed the

maximum received power of the corresponding modules. Otherwise, it will damage the

fiber transceiver. Do not stare at the fiber bore when the switch is in operation. That may

hurt your eyes.

2.3.6 AC Power Supply Connection

DG-GS4600SE2 series switches use 220V AC power supply by default. Please read

the power input specification for the detailed information.

AC Power supply connection procedure is described as below:

1. Insert one end of the power cable provided in the accessory kit into the power source

socket (with overload and leakage protection), and the other end to the power socket in

the back panel of the switch.

2. Check the power status indicator in the front panel of the switch. The corresponding

power indicator should light. DG-GS4600SE2 series is self-adjustable for the input voltage.

As soon as the input voltage is in the range printed on the switch surface, the switch can

operate correctly.

3. When the switch is powered on, it executes self-test procedure and startups.

Caution!

The input voltage must be within the required range, otherwise the switch can be

damaged or malfunction. Do not open the switch shell without permission. It can cause

physical injury.

DG-GS4600SE2 Installation Guide

Chapter 2-9