Digisol DG-GS4628FSE2 Посібник з монтажу - Сторінка 19
Переглянути онлайн або завантажити pdf Посібник з монтажу для Перемикач Digisol DG-GS4628FSE2. Digisol DG-GS4628FSE2 20 сторінок. Giga layer 3 switches
transceiver's TX port should be connected to the RX port of the corresponding device, and
vice versa.
Step 3: Check the fiber port status indicator, a lighted LED indicates that the link has been
established; otherwise the link is not ready and should be examined.
Caution!
Please verify the sign above the port to ensure using the other ports. Connecting to wrong
ports might damage the transceiver or the other ports. When connecting other devices
through a fiber cable to the switch, the output power of the fiber cable must not exceed the
maximum received power of the corresponding modules. Otherwise, it will damage the
fiber transceiver. Do not stare at the fiber bore when the switch is in operation. That may
hurt your eyes.
2.3.6 AC Power Supply Connection
DG-GS4600SE2 series switches use 220V AC power supply by default. Please read
the power input specification for the detailed information.
AC Power supply connection procedure is described as below:
1. Insert one end of the power cable provided in the accessory kit into the power source
socket (with overload and leakage protection), and the other end to the power socket in
the back panel of the switch.
2. Check the power status indicator in the front panel of the switch. The corresponding
power indicator should light. DG-GS4600SE2 series is self-adjustable for the input voltage.
As soon as the input voltage is in the range printed on the switch surface, the switch can
operate correctly.
3. When the switch is powered on, it executes self-test procedure and startups.
Caution!
The input voltage must be within the required range, otherwise the switch can be
damaged or malfunction. Do not open the switch shell without permission. It can cause
physical injury.
DG-GS4600SE2 Installation Guide
Chapter 2-9