Sharp AQUOS LC-20B10N Panduan Pengoperasian - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk TV LCD Sharp AQUOS LC-20B10N. Sharp AQUOS LC-20B10N 29 halaman. Lcd colour television
Halaman Cetak
Sound Volume
■ To adjust the volume
● Press VOL (+) to increase the sound volume.
The numerical value increases.
0
● Press VOL (–) to decrease the sound volume.
The numerical value decreases.
0
■ To mute the sound
● Press
(Mute) to temporarily turn off the sound. The
MUTE mark is displayed on the screen.
● Press
(Mute) or VOL (+)/(–) to turn the sound back to
the previous level. MUTE is automatically cleared when
one of the following buttons is pressed: POWER,
VOL (+)/(–) or
(Mute).
0
Basic Operation (Continued)
Changing Channels
You can select channels using Channel Select or CH (
• To handle the increasing number of channels available, this LCD
TV set allows you to select up to 100 posi tions (Channels 0 to
99). One-digit and two-digit methods of selection can be used.
Follow the pro cedure shown below to select channels.
■ Using Channel Select
To select a one-digit channel (e.g., Channel 5):
1
Press 5 of Channel Select.
2
If "5–" is indicated and the picture does not change,
press -/-- to switch over to the 1-digit select mode
and press 5 of Channel Select.
To select a two-digit channel (e.g., Channel 15):
1
Press -/-- to set the 2-digit select mode.
2
Press 1 of Channel Select.
3
Press 5 of Channel Select.
NOTE
• Complete this procedure within 4 seconds, other wise the
selection will not be made.
Changing channels with CH (
control.
Press CH (
) and the channels change in the order shown below:
1 → 2 → 3 → . . . → 98 → 99 → 0 → 1 → 2 → 3 → . . .
Press CH (
) and the channels change in the order shown below:
3 → 2 → 1 → 0 → 99 → 98 → . . . → 3 → 2 → 1 → . . .
■ Using A (Flashback)
● Press A to switch the currently tuned channel to the
previously tuned channel.
● Press A again to switch back to the currently tuned
channel.
)/(
).
)/(
) on the remote
11