Sharp CD-DH790NH Panduan Pengoperasian - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Sistem stereo Sharp CD-DH790NH. Sharp CD-DH790NH 34 halaman. Mini component system

Halaman Cetak
Listening to the iPod (continued)
■ To insert iPod adaptor
1
Press the ON/STAND-BY button to turn the power on.
2
Insert the iPod adaptor into the iPod dock and connect
your iPod.
iPod (bottom)
Dock connector
iPod adaptor
iPod dock
iPod connector
■ To remove iPod adaptor
Insert the tip of a screwdriver ("–" type, small) into the
iPod adaptor hole as shown and lift upward to remove.
ON/STAND-BY
ON/STAND-BY
iPod
■ iPod playback
1
Press the ON/STAND-BY button to turn the power on.
2
Press the iPod button on the remote control or
FUNCTION button repeatedly on the main unit to
select iPod function.
3
Insert iPod unit in iPod dock of main unit.
4
Press the
■ To disconnect iPod
Simply remove the iPod from the iPod dock. It is safe to do
so even during playback.
■ Navigating the iPod menus
1
Press the MENU button to view the menu on iPod unit.
Press it again to go back to previous menu.
2
Use the TUNING (
control to select an item on the menu and then press
ENTER button.
Note:
When navigating the iPod menus with remote control, do
not operate any of the buttons on the iPod unit. The volume
level is adjusted by pressing the VOL (+ or –) button on the
main unit or the remote control. Adjusting the volume on
the iPod unit gives no effect.
iPod operation:
The operations described below depend on the generation
iPod you are using.
System on operation:
When the main unit is powered on, the iPod unit will
automatically power on when docked in the unit (including
TIMER function/exclude USB function).
System off (stand-by operation):
When the main unit is turned to stand-by mode, the docked
iPod unit will automatically turn to stand-by mode.
E-8
MI NI COM PONENT SYSTEM
CD-DH790
FUNCTION
FUNCTION
ON/STAND-BY
ON/STAND-BY
VOL
VOL
CD
USB
/ button to start playback.
or
) button on the remote