Sharp CD-DH790NH 운영 매뉴얼 - 페이지 17

{카테고리_이름} Sharp CD-DH790NH에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sharp CD-DH790NH 34 페이지. Mini component system

페이지 인쇄

Listening to the iPod (continued)

■ To insert iPod adaptor

Press the ON/STAND-BY button to turn the power on.

Insert the iPod adaptor into the iPod dock and connect

your iPod.

iPod (bottom)

Dock connector

iPod adaptor

iPod dock

iPod connector

■ To remove iPod adaptor

Insert the tip of a screwdriver ("–" type, small) into the

iPod adaptor hole as shown and lift upward to remove.

ON/STAND-BY

iPod

■ iPod playback

Press the ON/STAND-BY button to turn the power on.

Press the iPod button on the remote control or

FUNCTION button repeatedly on the main unit to

select iPod function.

Insert iPod unit in iPod dock of main unit.

Press the

■ To disconnect iPod

Simply remove the iPod from the iPod dock. It is safe to do

so even during playback.

■ Navigating the iPod menus

Press the MENU button to view the menu on iPod unit.

Press it again to go back to previous menu.

Use the TUNING (

control to select an item on the menu and then press

ENTER button.

Note:

When navigating the iPod menus with remote control, do

not operate any of the buttons on the iPod unit. The volume

level is adjusted by pressing the VOL (+ or –) button on the

main unit or the remote control. Adjusting the volume on

the iPod unit gives no effect.

iPod operation:

The operations described below depend on the generation

iPod you are using.

System on operation:

When the main unit is powered on, the iPod unit will

automatically power on when docked in the unit (including

TIMER function/exclude USB function).

System off (stand-by operation):

When the main unit is turned to stand-by mode, the docked

iPod unit will automatically turn to stand-by mode.

E-8

MI NI COM PONENT SYSTEM

CD-DH790

FUNCTION

ON/STAND-BY

VOL

USB

/ button to start playback.

) button on the remote