Digital audio ACHAPELL AUDIO 992EG Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat Digital audio ACHAPELL AUDIO 992EG. Digital audio ACHAPELL AUDIO 992EG 11 halaman. Vacuum tube preamplifier for microphones and instruments

Halaman Cetak

HOOKUP

AC PEM: Double check the power setting on the power entry

module (PEM) is correct. In the USA it should always read 115v

on the red voltage indicator located just above the rear power

rocker switch. As stated above, use only a 3 prong detachable

AC power cord. See the SERVICE/REPAIR section for replacing the

fuse(s).

• XLR INPUT: Located on the rear panel are the balanced

Microphone XLR inputs. The pin orientation is standard.

• XLR OUTPUT: Above the XLR inputs are the balanced

XLR outputs. These outputs are to be connected to your

recording/broadcast console, recorder, or other devices that

can accommodate a balanced line level signal.

• Hi-Z INPUT: Located on the front panel are the auto-switching

Hi-Z instrument inputs. This Hi-Z stage is placed in front of the

balanced microphone input stage and utilizes a Cinemag

transformer for signal balancing.

METER

Meter

48v

Off

METER

-20 dB

TOGGLE

INPUT PAD

PHANTOM

POWER

FIGURE 2.1 The five LED tipped toggles on channel 1 are (from left to right) Meter, 48v, -20db, Polarity Reverse and Mute.

The two lower knobs on the inside are for input gain and the two upper knobs are for output gain.

CONTROLS

• TUBE DRIVE / INPUT GAIN: The INPUT controls how much of the source signal is fed to the first stages

of the vaccuum tube. Higher levels will drive the tube harder and result in more harmonics. Think

of this control as your anount of tube coloration/harmonics (distortion).

LACHAPELL AUDIO MODEL 992

OUTPUT

TUBE DRIVE

GAIN

INPUT GAIN

Model 992: Two Channel Fully Balanced Vacuum

Output Gain

-20

Mute

Off

Norm

Chl On

Hi-Z

CHANNEL

HI-Z

MUTE

INPUT

POLARITY

REVERSE

LaChapell Audio

Tube Preamplifier

Input Gain

Power

Off

Hi-Z

POWER

TOGGLE

INTERNATIONAL POWER

SETTINGS:

At this time power settings other

than 115v are only available as

a factory modification.

DO NOT attempt to use the

red voltage fuse sub module

for voltage adjustments. If

this modification has been

performed you will see the

corresponding check box

marked on the rear panel

accordingly. Contact Digital

Audio Labs if you have any

questions.

Output Gain

Mute

-20

48v

Chl On

Norm

Off

Meter

Off