Digital Audio Labs LIVEMIX MIX-32 Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengaduk Digital Audio Labs LIVEMIX MIX-32. Digital Audio Labs LIVEMIX MIX-32 15 halaman. Central mixer and power distributor
Juga untuk Digital Audio Labs LIVEMIX MIX-32: Panduan Pengguna (15 halaman)

Halaman Cetak

1. Setup and Operation

TROUBLESHOOTING

The Livemix MIX-16/MIX-32 is not powering on

correctly.

I am not seeing the "Livemix Data" light

illuminate.

I was planning on feeding the MIX-16/MIX-32

from my digital mixer, but do not see the right

connector to use on the MIX-16/MIX-32.

There is a clicking or popping sound in my mix.

LIVEMIX MIX-16/32

Verify that you have connected the external

power supply to a working power outlet.

Verify that the front panel power switch is set

to ON.

If the Livemix Data light is not illuminating,

there is a problem with the power to the MIX-

16/MIX-32. Check to make sure that the power

supply is connected to the MIX-16/MIX-32 and

that all the cables are secure. Also verify that the

power supply is plugged into an appropriate

power source and that the power cable from

the source to the power supply transformer is

securely attached.

The MIX-16/MIX-32 interfaces with digital

consoles through the use of an option card that

inserts into the MIX-16/MIX-32.

Audible clicking and popping is usually an

issue with the clock source. If you are using

Livemix with a Dante network, make sure that

your console or Dante device is set to be the

Master and Livemix is set to be the Slave.

This can be done through Dante Controller

software on a Windows PC or Apple computer.

NOTE: If you desire to have your console's

internal clock be the clock source, select this

configuration setting on your console. Then

in Dante Controller, set your console's Dante

option card to be the Master Dante device

on the Dante network and select "Sync to

External".