Digital Audio Labs LIVEMIX MIX-32 사용자 설명서 - 페이지 12

{카테고리_이름} Digital Audio Labs LIVEMIX MIX-32에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digital Audio Labs LIVEMIX MIX-32 15 페이지. Central mixer and power distributor
Digital Audio Labs LIVEMIX MIX-32에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지)

페이지 인쇄

1. Setup and Operation

TROUBLESHOOTING

The Livemix MIX-16/MIX-32 is not powering on

correctly.

I am not seeing the "Livemix Data" light

illuminate.

I was planning on feeding the MIX-16/MIX-32

from my digital mixer, but do not see the right

connector to use on the MIX-16/MIX-32.

There is a clicking or popping sound in my mix.

LIVEMIX MIX-16/32

Verify that you have connected the external

power supply to a working power outlet.

Verify that the front panel power switch is set

to ON.

If the Livemix Data light is not illuminating,

there is a problem with the power to the MIX-

16/MIX-32. Check to make sure that the power

supply is connected to the MIX-16/MIX-32 and

that all the cables are secure. Also verify that the

power supply is plugged into an appropriate

power source and that the power cable from

the source to the power supply transformer is

securely attached.

The MIX-16/MIX-32 interfaces with digital

consoles through the use of an option card that

inserts into the MIX-16/MIX-32.

Audible clicking and popping is usually an

issue with the clock source. If you are using

Livemix with a Dante network, make sure that

your console or Dante device is set to be the

Master and Livemix is set to be the Slave.

This can be done through Dante Controller

software on a Windows PC or Apple computer.

NOTE: If you desire to have your console's

internal clock be the clock source, select this

configuration setting on your console. Then

in Dante Controller, set your console's Dante

option card to be the Master Dante device

on the Dante network and select "Sync to

External".