DIGITAL DELAY Mega 400 Petunjuk Manual - Halaman 10

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Aksesori Mobil DIGITAL DELAY Mega 400. DIGITAL DELAY Mega 400 14 halaman.

The Peak RPM is shown on the display in place of the Tach any time the engine is off. The Peak RPM value will be

the highest RPM the engine has reached since the last time the Peak RPM cleared. To clear the Peak RPM, repeatedly press

the F key until the letters A and B are shown next to the Tach and Shift Point.

If the words "Peak RPM" are being shown on the screen, press the A key and the Peak RPM will be set to zero. If the engine

is on when the A key is pressed nothing will happen.

Explanation of the 4-Stage Timer

This is to help the racer understand the 4-Stage Timer when controlling a throttle stop. The 4-Stage Timer can also be

used to control other timed devices, nitrous, or timing retarders.

Stage 1 represents when the throttle stop turns on. Stage 2 represents the amount of time (duration) the throttle stop

will stay on. Stage 3 represents when the throttle stop will turn on the second time during the run. Stage 4 represents the

amount of time (or duration) the throttle stays on the second time. Both Stage 1 and Stage 3 start counting from the release of

the Transbrake. Stage 2 starts counting after the amount of time set in Stage 1 is completed. Stage 4 starts counting after the

amount of time set in Stage 3 is completed.

Explanation of the Starting Line Enhancer

This is to help the racer understand how the Starting Line Enhancer works. When turned on, the Starting Line

Enhancer will close the throttle under two different conditions, first if the Tap push-button is pressed before a Transbrake

button and second when the Transbrake Push Button is pressed. After the throttle has been closed the Starting Line Enhancer

will open the throttle at the programmed amount of time before the Transbrake is released.

Explanation of the Peak RPM

Possible 8.90 S/C pass

Timer 1 = 1.000

Timer 2 = 2.000

Timer 3 = 08.00

Timer 4 = 00.50

Crossover Delay = 01.35

Starting Line Enhancer = 00.40

Timer 1

Timer 2

Timer 3

Timer 4

= 1.000

= 2.000

= 08.00

= 00.50