Siemens SIMATIC ET 200SP Manual - Halaman 15

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Industri Siemens SIMATIC ET 200SP. Siemens SIMATIC ET 200SP 36 halaman. Distributed i/o system
Juga untuk Siemens SIMATIC ET 200SP: Manual (40 halaman), Panduan Pengguna (21 halaman), Manual (34 halaman), Manual (48 halaman), Manual (30 halaman), Manual (34 halaman), Informasi Produk (38 halaman), Manual (37 halaman), Manual (44 halaman), Manual (31 halaman), Manual (35 halaman), Manual (23 halaman), Panduan Konfigurasi (20 halaman), Manual (34 halaman), Manual (29 halaman), Manual (33 halaman), Manual (31 halaman), Panduan Pengguna (32 halaman), Manual (31 halaman), Manual (28 halaman), Manual (41 halaman), Manual (32 halaman), Manual (49 halaman), Manual (24 halaman), Manual (34 halaman), Manual (41 halaman), Manual (30 halaman), Manual (31 halaman), Manual (27 halaman), Manual (24 halaman), Manual (24 halaman), Manual (25 halaman), Manual (49 halaman), Manual (40 halaman), Manual (38 halaman), Manual (39 halaman), Informasi Produk (24 halaman), Manual (32 halaman), Informasi Produk (10 halaman), Panduan Peralatan (43 halaman), Manual (33 halaman), Panduan Peralatan (44 halaman), Petunjuk Pengoperasian Asli (6 halaman), Manual (35 halaman), Manual (28 halaman), Panduan Peralatan (32 halaman), Manual (50 halaman), Manual (30 halaman), Manual (26 halaman), Manual (28 halaman), Manual (34 halaman), Manual (44 halaman), Manual (33 halaman), Panduan Peralatan (42 halaman), Manual Petunjuk Asli (16 halaman)

4.3

Explanation of the module/channel parameters

Diagnostics, Missing supply voltage L+

Enabling of the diagnostics for missing or insufficient supply voltage L+.

IO redundancy

You can configure two identical modules redundantly. To do so, plug both modules into a

redundant terminal block side by side. You can find additional information on mounting

modules in an IO redundancy configuration in the ET 200SP HA System Manual, section

"Installing", "Installing terminal block".

In IO redundancy mode, the left-hand module is the master and the right-hand module is the

slave.

Both redundant modules measure simultaneously and independently in the process. Both

redundant modules generate diagnostics, alarms and process values.

Diagnostics, Short-circuit to ground

When the digital output is enabled, you can enable diagnostics that report a digital output short

circuit to M.

Diagnostics short-circuit to L+

When the digital output is enabled, you can enable diagnostics that report a digital output short

circuit to L+.

Diagnostics, Wire break

With activated wire break checking, the diagnostics are enabled when the line is from the

actuator is interrupted.

Check for wire break

Enable for wire break check. The I/O module can only detect a wire break if wire-break is

activated.

Channel activated

Specifies whether a channel is activated or deactivated.

Reaction to CPU STOP

Determines the reaction of the digital output to CPU STOP or to failure of communication

between the interface module and CPU.

Digital output module DQ 16x24VDC/0.5A (6DL1132-6BH00-0PH1)

Manual, 05/2017, A5E39265993-AA

4.3 Explanation of the module/channel parameters

Parameters