Siemens SIMATIC ET 200SP Panduan Konfigurasi - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Peralatan Industri Siemens SIMATIC ET 200SP. Siemens SIMATIC ET 200SP 20 halaman. Distributed i/o system
Juga untuk Siemens SIMATIC ET 200SP: Manual (40 halaman), Panduan Pengguna (21 halaman), Manual (34 halaman), Manual (48 halaman), Manual (30 halaman), Manual (34 halaman), Informasi Produk (38 halaman), Manual (37 halaman), Manual (36 halaman), Manual (44 halaman), Manual (31 halaman), Manual (35 halaman), Manual (23 halaman), Manual (34 halaman), Manual (29 halaman), Manual (33 halaman), Manual (31 halaman), Panduan Pengguna (32 halaman), Manual (31 halaman), Manual (28 halaman), Manual (41 halaman), Manual (32 halaman), Manual (49 halaman), Manual (24 halaman), Manual (34 halaman), Manual (41 halaman), Manual (30 halaman), Manual (31 halaman), Manual (27 halaman), Manual (24 halaman), Manual (24 halaman), Manual (25 halaman), Manual (49 halaman), Manual (40 halaman), Manual (38 halaman), Manual (39 halaman), Informasi Produk (24 halaman), Manual (32 halaman), Informasi Produk (10 halaman), Panduan Peralatan (43 halaman), Manual (33 halaman), Panduan Peralatan (44 halaman), Petunjuk Pengoperasian Asli (6 halaman), Manual (35 halaman), Manual (28 halaman), Panduan Peralatan (32 halaman), Manual (50 halaman), Manual (30 halaman), Manual (26 halaman), Manual (28 halaman), Manual (34 halaman), Manual (44 halaman), Manual (33 halaman), Panduan Peralatan (42 halaman), Manual Petunjuk Asli (16 halaman)

3 Configuration

3.2.3

Adjusting the real time settings

To make sure that all IO controllers and "Shared Devices" are operated with the

appropriate send clock and the update times are correctly calculated due to the

communications burden, you need to adjust and check the following settings.

Proceed as follows:

1. In project 1 / project 2, mark the interface module of the "Shared Device" in the

network view.

2. In the inspector window, navigate to:

"PROFINET interface" > "Advanced options" > "Real time settings" > "IO cycle".

In the "Shared Device" area, set the number of project-external IO controllers.

Figure 3-7

Note

The maximum possible number of IO controllers depends on the IO device and

is store in the GSD file.

SharedDeviceKonfig

Entry ID: 109741600,

V1.0,

11/2016