Siemens SIMATIC ET 200SP HA Panduan Peralatan - Halaman 23

Jelajahi secara online atau unduh pdf Panduan Peralatan untuk Peralatan Industri Siemens SIMATIC ET 200SP HA. Siemens SIMATIC ET 200SP HA 44 halaman. Distributed i/o devices busadapter for distributed i/o
Juga untuk Siemens SIMATIC ET 200SP HA: Manual (32 halaman), Manual (50 halaman), Manual (34 halaman), Manual (38 halaman), Panduan Peralatan (50 halaman), Panduan Peralatan (38 halaman), Panduan Peralatan (46 halaman), Panduan Peralatan (42 halaman), Panduan Peralatan (44 halaman), Panduan Peralatan (36 halaman), Panduan Peralatan (38 halaman)

4.6

BusAdapter BA LC/FC

Introduction

Plug

Front view

You connect the IO device to the PROFINET IO system via BusAdapter BA LC/FC.

The node communicates via two ports.

● Port 1 offers the option of connecting an LC connector.

When data is transferred via port 1, it is first sent as a differential signal to the LC transceiver.

It is converted there for optical data transmission and vice versa.

● Port 2 allows the connection of a FastConnect cable.

When data is transmitted via port 2, the differential signals of the base device are output

electrically isolated via the BusAdapter.

The overvoltage protection must be implemented by the base device. The reverse polarity

protection is realized by the BA housing.

Assembling the cable

● You can find information on assembling the FC cables in the section "Pin assignment of the

FC outlet (4-pin connector) (Page 32)".

BusAdapter for Distributed I/O

Equipment Manual, 09/2019, A5E39261458-AB

Description

①

LED LK 1 - Status of Ethernet connection port 1

②

LED LK 2 - Status of Ethernet connection port 2

You can find information on this in section "Diagnostics via LED

displays (Page 29)".

③

Connection diagram for the PROFINET connectors (view

from below)

● IO port 1 = LC (optical connection)

● IO port 2 = FC (electrical connection)

④

Fixing screw

⑤

Tightening torque

Installation

4.6 BusAdapter BA LC/FC