Siemens SIMATIC ET 200SP HA 장비 매뉴얼 - 페이지 23

{카테고리_이름} Siemens SIMATIC ET 200SP HA에 대한 장비 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SIMATIC ET 200SP HA 44 페이지. Distributed i/o devices busadapter for distributed i/o
Siemens SIMATIC ET 200SP HA에 대해서도 마찬가지입니다: 매뉴얼 (32 페이지), 매뉴얼 (50 페이지), 매뉴얼 (34 페이지), 매뉴얼 (38 페이지), 장비 매뉴얼 (50 페이지), 장비 매뉴얼 (38 페이지), 장비 매뉴얼 (46 페이지), 장비 매뉴얼 (42 페이지), 장비 매뉴얼 (44 페이지), 장비 매뉴얼 (36 페이지), 장비 매뉴얼 (38 페이지)

페이지 인쇄
Siemens SIMATIC ET 200SP HA 장비 매뉴얼
4.6

BusAdapter BA LC/FC

Introduction
Plug
Front view
4
You connect the IO device to the PROFINET IO system via BusAdapter BA LC/FC.
The node communicates via two ports.
● Port 1 offers the option of connecting an LC connector.
When data is transferred via port 1, it is first sent as a differential signal to the LC transceiver.
It is converted there for optical data transmission and vice versa.
● Port 2 allows the connection of a FastConnect cable.
When data is transmitted via port 2, the differential signals of the base device are output
electrically isolated via the BusAdapter.
The overvoltage protection must be implemented by the base device. The reverse polarity
protection is realized by the BA housing.
Assembling the cable
● You can find information on assembling the FC cables in the section "Pin assignment of the
FC outlet (4-pin connector) (Page 32)".
BusAdapter for Distributed I/O
Equipment Manual, 09/2019, A5E39261458-AB
3
Description
①
LED LK 1 - Status of Ethernet connection port 1
5
②
LED LK 2 - Status of Ethernet connection port 2
You can find information on this in section "Diagnostics via LED
displays (Page 29)".
③
Connection diagram for the PROFINET connectors (view
from below)
● IO port 1 = LC (optical connection)
● IO port 2 = FC (electrical connection)
④
Fixing screw
1
⑤
Tightening torque
2
Installation
4.6 BusAdapter BA LC/FC
23